CAB Apollo 1 Manuel de l'opérateur télécharger pdf (Page 57)

57cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.

Label Sensor

The printers of the Apollo series offer different methods for recognizing the

front edge of the label.

In most cases, the label edge sensor photocell can be used in the see-through

mode ("Gap sensor" mode), where the different transparency of the material is

used to distinguish between the labels and the gaps.

In certain cases, for instance when pre-printed continuous paper is used, the

label edge can also be recognized through reflective marks. (see also section

about label formats; page 20) All versions of the Apollo offer the see-through

mode and reflective mark recognition on the bottom side of the material. In

addition, Apollo 1 and Apollo 2 are also able to recognize reflective marks on

the top of the material.

NOTICE !

This parameter can also be changed via software. For different print jobs

it is recommended to make all changes in the software.

Default Setting : Gap sensor

2 Transfer print

3 Label sensor

4 Interface

Selection

Label sensor

Gap sensor

Label sensor

Bottom-Reflect

Label sensor

Top-Reflect

Label sensor

xxx Yes

Label sensor

xxx No

Confirmation

Selection

Label sensor

Gap sensor

Label sensor

Bottom-Reflect

1 Apollo 1

2 Apollo 2

3 Apollo 3

Fig. 9 d Set "Label sensor" parameter

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 138 139

Pas de commentaire

CAB Apollo 1 Manuel de l'opérateur Page 57