CAB A6 Manuel de l'opérateur télécharger pdf (Page 125)

E-3cab Produkttechnik GmbH & Co KG

A3-2 / A3 / A4 / A6

18 9 10 8 11 6

6. Carefully unplug the printhead (1) from the connectors of the printhead

cables (9 and 10).

7. Connect the new printhead to the cables.

8. Place the printhead into the assembly and insert the holes (8) onto the

pins (11).

9. Tighten the locking screw (5) by hand. Check that the printhead is

completely secured in the printhead carriage.

10. Swing the lever (6) again into the position shown in figure E-2.

11. Tighten the locking screw (5) completely. Do not over-tighten the locking

screw (5).

Fig. E-3 Changing Printhead A3-2/A3/A4 (II)

Appendix E - Replacing Assembly Units

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 137 138

Pas de commentaire

CAB A6 Manuel de l'opérateur Page 125