CAB A8+ Manuel de l'opérateur télécharger pdf (Page 106)

B-8 cab Produkttechnik GmbH & Co KG

Cause and Solution

Printhead is dirty, clean the printhead (appendix C).

Printhead is defective (failure of heating elements), replace

the printhead.

Printer is being used with backfeed set to "smart" in cut or

dispense mode (see chapter 8). Set backfeed to "always" in

the Setup.

Printhead is dirty, clean the printhead (appendix C).

The printhead support is not adjusted for the width of the

media. Readjust the printhead support (see chapter 7).

Transfer ribbon is not secured to the ribbon supply hub.

Tighten the knob on the ribbon supply hub (see chapter 7).

Problem

Vertical white lines in the print

image

Horizontal white lines in the

print image

Print image is irregular or one

side is lighter than the other

side.

"Ribbon out" message appears

when ribbon is loaded

Table B-4 Problems / Solutions (continued)

Appendix B - Error Messages / Problem Solution

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 119 120

Pas de commentaire

CAB A8+ Manuel de l'opérateur Page 106