CAB A8+ Manuel de l'opérateur télécharger pdf (Page 45)

45cab Produkttechnik GmbH & Co KG

Loading Fanfold Labels

Fig. 7h Loading Fanfold Labels

1. Open the cover.

2. Loosen the knurled screw (5) and slide the media guide (6) to its

outermost position. Rotate the media guide (6) downwards past the media

unwinder (7).

3. Remove the adapters.

4. Place the stack of media (8) behind the printer. Make sure the labels on

the media strip are facing up.

5. To raise the printhead assembly (3), rotate the lever (2) clockwise until it

stops.

6. Swing down the plate (1).

7. Slide the media guide ring (4) outward, allowing enough clearance for the

media's width when loaded.

8. Slide the media strip through the printer as shown in figure 7h.

9. Adjust the label edge sensor so, that the sensor can recognize the space

between the labels respectively the reflective or the perforation mark.

10. Slide the media guide (6) inward until it lightly touches the media strip.

Rotate the media guide upwards against the media unwinder (7) and

tighten the knurled screw (5).

11. Slide the media guide ring (4) inward until it lightly touches the media strip.

12. Swing back the plate (1) to the print mechanism.

13. Lower the printhead by rotating the lever (2) counter-clockwise until it

stops.

NOTICE !

When printing narrow label stock please activate the printhead support as

described in the previous chapter !

7. Media Loading

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Pas de commentaire

CAB A8+ Manuel de l'opérateur Page 45